EFS Bar Parking Sensor Holder

Suits front and rear EFS bars where fitting with parking sensors is required.

4 per pack.

Fitment Notes

Sensor holes in bars normally require step drilling to 27mm to accept these sensor holders.

Important Notice: Sensor Recalibration May Be Required

Some newer generation vehicles are equipped with advanced driver assistance systems (ADAS) that may require sensor recalibration after a bullbar has been installed. This recalibration is something that will need to be performed by your vehicle's dealership or a specialist technician at your own cost.

Please note:

• Not all vehicles require recalibration.
• The need for recalibration is typically identified after installation, if fault codes appear or warning lights display on your vehicle’s dashboard.
• If no faults appear, no further action is required.
• If faults are present, recalibration is necessary to ensure your vehicle's safety systems continue to operate correctly.